Page 5 - ATP PACKS_2016

ATP® PACK 03 ROOMS FROM
17 TO 24 M2
Packs
2009 03

EXCELLENCE STANDARD

Sabine: 0.47 sec Sabine: 0.53 sec

DESCRIPTION ABSORPTION COEFFICIENT AND GRAPHIC

The ATP® PACK 03 is an acoustic panel set designed for rooms measuring between 17 and 24 square 1,0 RT [s] Excellence
metres. This set of panels has been therefore prepared for medium-sized rooms, which are probably STANDARD
the most usual ones. 0,8
The presence of acoustic panels in a room helps to enhance, in the most real way, the sound produced Freq[Hz]
by its system, thus improving the soundstage and the channel separation. 0,6
The next step is to optimise the acoustic coupling between the listener and the speakers, while 250 500 1000 2000 4000
minimising the SBIR and the modal emphasis to produce a frequency response as flat as possible in the 0,4
room. 125 Hz 250 Hz 500 Hz 1 Khz 2 Khz 4 Khz RT60
It uses low-frequency tuned modules, BKA120 and BKW120, which are duly balanced with the 0,2 0.52 0.49 0.49 0.48 0.44 0.42 0.47
absorbers and diffusers FSO060 and WAV060, as pictures show. 0.71 0.55 0.52 0.50 0.47 0.42 0.53
It is imperative to use these modules in this type of rooms in order to hold the energy at low frequencies. 0
You can choose from the two ATP® PACK 03 available solutions: STANDARD or EXCELLENCE, 125
depending on your needs and aesthetic taste.
It is a very practical assembly kit and is provided with assembly instructions, as well as the glues and FREQUENCY
tools which are necessary to install the acoustic modules. aS
aS
WHERE TO APPLY :
Rooms with an area between: 17 and 24 square meters. PACK QUANTITIES
Rooms with volumes between: 45 and 58 cubic meters.
For use in medium-sized home-theatre rooms, home-studios, Hi-fi rooms or instrument rooms. REFERENCE PANELS UNITS DIFFUSOR ABSORBENT TUNED
WAV060 / WAI060 WAVYFUSER/INV 18 DIFFUSOR ABSORBENT TUNED
FEATURES FSO060 / FSI060 FOAMSORB/INV 18
BASSKEEPER ANGLE 8
• Values were obtained by simulation in specific JAS® software and later confirmed BKA120 BASSKEEPER WALL 4
through acoustic analyses in the rooms. BKW120
UNITS
• The simulated and tested rooms are totally empty, and only the referred 18
ATP® PACK 03 acoustic panels are applied. 8

• Traditional construction room with dimensions: (L,W,H): 5.82m / 4.00m / 2.50m.
Walls: masonry with painted fine stuff and a wooden door.
Ceiling: 12 mm - thick plaster.
Floor: natural floating parquet.
ATP® PACK 03 REFERENCE PANELS
BEIGE STS120 STRIPESORB
Similar to T3S120
RAL 1011 TRAP 30S
YELLOW
Similar to
RAL 1003
ORANGE
Similar to
RAL 2001
RED
Similar to
RAL 3003
PURPLE
Similar to
RAL 4007
LIGHT BLUE
Similar to
RAL 5010
BLUE
Similar to
RAL 5013
GREEN
Similar to
RAL 6028
BROWN
Similar to
RAL 8019
LIGHT GREY
Similar to
RAL 7001
GREY
Similar to
RAL 7015
BLACK
Similar to
RAL 9005
WHITE
Similar to
RAL 9003
STANDARD EPS RAL COLOURS REGULAR FOAM COLOURS

CREAM GREY
Regular Foam Regular Foam

98 IMPORTANT NOTICES

• JOCAVI® accepts no responsibility for any printing errors. Specifications can be modified without prior notice, if technical or commercial reasons so require.
• The colours shown on this catalogue are only a reference and an illustration of the products finishing. The colours shown are not binding because brightness, contrast and colour balance may vary due to the printing process.
• Colours may vary due to raw-material suppliers' changes and some differences may occur in tonal range.
• Typical Indoor Comfort Standards state a temperature range of 20ºC - 27ºC (68ºF - 81ºF), and a relative humidity of less than 60%. These would be considered as normal operational levels of JOCAVI® products' range.
• Despite all the standard sizes of all products, this model can be customised upon previous consultation. Sizes may vary slightly due to their production method and some inherent raw-materials characteristics.